做一款企業真正好用的3D打印機

站内搜索

搜索關健字: ,共有 234 條記錄

 

Filament winding around spool holder

Before leaving the factory, EcubMaker has already put spool holders, guiding tubes (white tubes) and filament supports (metal supports) in the package. The correct installation method is as follows:For EcubMaker filament, the best installation way is the

Extruder fan does not rotate

Extruder fan does not rotateUnder normal circumstances, the extruder fans begin to work only when preheating temperature of extruder reaches 70 ℃ or above. That is to say, if the the temperature that thermocouple detected is below 70 ℃, the fans does not…

No filament extruded or the extruded filament is very sparse

No filament extruded or the extruded filament is very sparseThe content of this chapter is very similar to printing offset, mainly discusses the mechanical and electrical problems of motor. It is brief introduced here.> Preheat the extruder and feed t

Printing offset

The offset refers the offset distance has already reached centimeter amount, but not the deviation of repeating position or the deviation of base quantity within the range of millimeter amount. Look at the above pictures, the left one is the normal offset

Extruder moves irregularly

Extruder moves irregularlyThe irregular movement includes the termination, pause, moving to the area beyond the normal printing range in the printing process and other abnormal movement. Such problems are usually caused by the electromagnetic interference

Prints can not stick to the plate

> The prior solution is to adjust slicing parameters. Such as rising the plate temperature (set PLA above 70 ℃, set ABS above 100 ℃ ), adding raft, adjusting the percentage of the first floor to 150~200%;> Enclose the printing cavity > Clean the…

The damage of plate

Because the material of pyroceram plate is glass, it is easy to rupture during transportation, We have taken a lot of measures to prevent it from damaging and in almost situation, it is safe. However, if the pyroceram plate slightly cracks, it has no eff

Plate is uneven

The supplier of pyroceram can controls its smoothness within 0.15mm from the manufacture process that equals to the thickness of one layer. In theory, the manufacture process can not absolutely make sure its flat. However, the degree of unevenness for alu

Nozzle is not in the same level

Nozzle is not in the same level

Wear or tear of nozzle

Wear or tear of nozzle

Jam of nozzle

There are many reasons for jam, it needs to do specific analysis according to different situations and uses specific solutions. Refer to the picture of dual extruder kit, for different locations of the jam, it usually has following solutions:1. Nozzle

Failed to print

Failed to print Choose the target file and click the print function, the normal processes is:①Heating up the board ②Heating up the extruder ③ Move the X,Y,Z axis to home position ④Extruder loads filament about 45mm in advance ⑤After that, extruder mov…

Failed to read the SD card

Failed to read the SD card In the normal condition, when the printer powers on, inset the SD card , the OLED screen will refresh one time. In the printing menu, the gcode files will show in English while Other format files and languages can not display in

Abnormal Preheating

Abnormal Preheating 1 The preheating target temperature of extruder shows abnormal date ( 0 ℃ or 1036 ℃ such as extreme temperature) Thermocouple is poor contact or broken. It needs to change a fine thermocouple to verify the two possibilities . Lear…

Unable to restart the printer

Unable to restart the printer ( Neither printer’s lights nor display doesn’t work when powering on.) Change another place to get the electricity, making sure the power supply is in a proper condition. Change another power cord which is the …